Followers

Saturday, July 3, 2010

Sdkfz 222


The Sdkfz 222 armored car was very common in WWII. These resin kits are so old, I am not sure who actually made it.

Not great, but these have been sitting around in my collection for at least five years. I think I got them when I purchased a collection. As you can see, they need a lot of flash cleaned up before they will be in good shape.


An initial assembly of the vehicle. These will probably end up in my Africa Korps units. Bill Jr. Custom Models makes a 222 armored car, but this one is not nearly as good.


Look at this gun, a lot of flash to trim off. These delicate parts require very careful handling. I use only the sharpest new knife blades on a job like this.



The wheels were cast as one part with a single open face mold. No detail on the back. I will drill them out and add a wire axle. I don't intend to make them roll, but an axle makes the wheels stronger.

4 comments:

Karcuss said...

these look good,
The Difference between earlier and later versions is the front two Vision slots are a bigger one for the driver and smaller offset on earlier versions.
And these in the photos are Mid production.
Are there going to be any with the 20mm gun mounted on the turret top

Sd.Kfz 221 LEICHTE PANZERSPAHWAGEN (s.Pz.B.41)

would they be 1/72 ish or at least for 20mm.

I like the 221, 222, 223 etc and 260 261 series and the 232 233 234 etc etc, but don't let me start on my thing with German ACs and HTs and actually my venture into all 1/35 WW2 ACs

nice work Bunker

Cheers Karcuss

Mike Bunkermeister Creek said...

Thanks for the info Karcuss!

nubian said...

that 222 may be by Frontline Wargaming.
as you say its an old kit. the more recent kits have far less flash.

Mike Bunkermeister Creek said...

I think the 222 are 1/87 rather than 1/76 or 1/72, but who knows?