Mass Chair Production

More work done on the chairs for the Kiss Kiss club.  The lower half of the photo shows chairs that have been bent into shape.

My notes on how to put the chairs together.  The circles are the wire, it is important to bend the wire inside the other wires so you have a square box.

I have started gluing the chair seats and back into place.  I dab of Goo contact cement holds the seat and back on quickly.  The seat and back were not precision cut and will be trimmed to fit each specific chair later in the process.

Mass chair production in effect.

Once the seats have dried for 24 hours, I then run some gap filling super glue by Loctite Super Glue Ultragel Control in the black and blue bottle around the wire and seats to fill in any gaps and strengthen the bond.  I then trim off any excess seat or back with my sprue cutter.  Finally, I use a sanding stick to sand down the seat and back, and also the wire points where the wire was cut into shape.  I am not going for perfect, but for inexpensive, durable, and easy to make.  They seem to look good in mass.