Kiss Kiss Dance Floor and Chairs

Long table with a 1/72nd scale figure seated at on one of the chairs I made.

You can see the wire for the chairs before bending.  The wire is 1/4 inch mesh squares, half the size of the wire mesh for the tables.

I used 1/4 inch angle pieces from Evergreen Plastic to make the actual seats and seat backs, resting on the wire form.

I cut these shapes out of the wire and since I needed 88 of them I laid them out on my cutting board to keep track of how many I had.  I also laid out the plastic parts, but ran out of plastic and had not purchased any more until after this photo was taken.

Dollar Tree has these and other little pieces of acrylic board in their craft section.

I intend to square it off and use it for the dance floor for the Kiss Kiss Club.