Bases For Everyone

I got a few 3D printed figures recently that did not have a base on them.

So I took my trusty Evergreen Scale Models 4504 1/6 square .040" think sheet styrene and made bases.

When using your Loctite adhesive in the fancy applicator and it's empty, open the bottom of the container and finish the tube.  This is the power flex which seems to work very well on plastic.

Scruff up the base and the bottom of the figures feet and use a pliers to hold the figures if necessary.  No teeth on these pliers.

Create a few lumps of clay.

Put a dab of glue on each foot, and place the figure on the base.  Use the lump of clay to hold them in place for a little while until dry.